Fabric weight standard test method for Mass Per Unit Area (weight) of fabric using ASTM Test Method D ASTM D Standard Test Method for Mass Per Unit Area (Weight) of Fabric1 – Download as PDF File .pdf), Text File .txt) or read online. ASTM D The ASTM D Basis weight test method covers four methods for the measurement of fabric mass per unit area (weight). It is applicable to most fabrics.
|Published (Last):||5 July 2007|
|PDF File Size:||11.45 Mb|
|ePub File Size:||17.94 Mb|
|Price:||Free* [*Free Regsitration Required]|
Measurements by this method do not include astm d3776 and should be reported as such, unless a selvage allowance is specified. Link to Active Astm d3776 link will always route to the current Active version of the standard. Historical Version s – view previous versions of standard. D376 C on the other hand is applicable when a small swatch of fabric is sent to the laboratory to be used as the test specimen.
ASTM D Standard Test Method for Mass Per Unit Area (Weight) of Fabric1_百度文库
Unless otherwise specified, these results will include selvages and will d7376 on the basis of conditioned fabric. This abstract astm d3776 a brief summary of the referenced standard. ASTM does not give astm d3776 warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
The last option is Option D d33776 is intended for use astm d3776 narrow fabrics as so designated by the trade. These test methods cover the measurement of fabric mass per unit area weight and is applicable to most fabrics.
It is astm d3776 responsibility of the user of this standard to establish appropriate safety astm d3776 health practices and determine the applicability of regulatory limitations prior to use. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
There are four approved options in the measurement of fabric mass per unit area: The results are considered to be applicable to the sample only and not necessarily to the lot from which the sample was taken. The second option is Option B which is astm d3776 to a full-width sample cut from a full piece, roll, bolt, or cut.
Option A may be used for acceptance testing of commercial shipments since it has been astm d3776 extensively in the trade. Work Item s – proposed revisions of this standard.
The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may astm d3776 in non-conformance with the standard.
It is informational astm d3776 and not an official part of the standard; the full text of the standard itself must be referred d376 for its use and application.